Logo

P2762 Engine Trouble Code

Meaning of P2762 engine trouble code is : When the check engine light comes P2762 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

P2762 Possible Solution:

P2762 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P2762 Code Meaning :

P 2 7 6 2
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Rail Pressure Sensor Circuit Malfunction Cylinder 4 Contribution/Balance Fault Glow Plug/Heater Circuit 'A' Malfunction

The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.

P2762 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2762 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Reason For P2762 Code

The reason of P2762 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

P2762 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.